AsconfWithSetNoExists.seq - ASCONF chunk is received with Set Primary Address Parameter which contain a address not part of the association
To check that if ASCONF chunk is received with Set Primary Address Parameter
which contain a address not part of the association then the endpoint should
responded with ASCONF-ACK chunk including cause of Unresolvable Address.
./AsconfWithSetNoExists.seq [-tooloption ...] -pkt ./AsconfWithSetNoExists.def
-tooloption : v6eval tool option
See Also: ../common/STD_PKT_COMMON.def
../common/SCTP_COMMON.def
Association is established between endpoint A and B. Arrange the date
in endpoint A such that ASCONF chunk with Set Primary Address Parameter
which contain a address not part of the association is sent to
endpoint B.
Endpoint A Endpoint B ULP
(ESTABLISHED) (ESTABLISHED)
ASCONF ----------------->
(Set Primary Address Parameter)
<----------------- ASCONF-ACK
(Unresolvable Address)
TEST DESCRIPTION:
1. Send ASCONF chunk from endpoint A to B with Set Primary Address Parameter
which contain a address not part of the association.
2. Check A: ASCONF-ACK with with Error Cause Indication Parameter which
including cause of Unresolvable Address should be received at endpoint A.
None
RFC 5061
4.2.4. Set Primary IP Address
0 1 2 3
0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| Type =0xC004 | Length = Variable |
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| ASCONF-Request Correlation ID |
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| Address Parameter |
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
ASCONF-Request Correlation ID: 32 bits
This is an opaque integer assigned by the sender to identify each
request parameter. The receiver of the ASCONF Chunk will copy this
32-bit value into the ASCONF Response Correlation ID field of the
ASCONF-ACK response parameter. The sender of the ASCONF can use this
same value in the ASCONF-ACK to find which request the response is
for. Note that the receiver MUST NOT change this 32-bit value.
Address Parameter: TLV
This field contains an IPv4 or IPv6 address parameter as described in
Section 3.3.2.1 of [RFC4960]. The complete TLV is wrapped within
this parameter. It requests the receiver to mark the specified
address as the primary address to send data to (see Section 5.1.2 of
[RFC4960]). The receiver MAY mark this as its primary address upon
receiving this request. If the address 0.0.0.0 or ::0 is provided,
the receiver MAY mark the source address of the packet as its
primary.