AuthWithoutCapable.seq - Authentication Chunk is received from endpoint which has no AUTH capable
None
./AuthWithoutCapable.seq [-tooloption ...] -pkt ./AuthWithoutCapable.def
-tooloption : v6eval tool option
See Also: ../common/STD_PKT_COMMON.def
../common/SCTP_COMMON.def
Association is established between endpoint A and B. Arrange data
in endpoint A such that AUTH chunk is sent to endpoint B.
Endpoint A Endpoint B ULP
(ESTABLISHED) (ESTABLISHED)
AUTH ------------------>
Silently discard
TEST DESCRIPTION:
1. Send AUTH chunk from endpoint A to B with Unsupported HMAC
Identifier.
2. Check A: ERROR should not be received at endpoint A. AUTH
chunk is silently discarded.
None
RFC 4895
5.1. Authentication Chunk (AUTH)
This chunk is used to hold the result of the HMAC calculation.
0 1 2 3
0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| Type = 0x0F | Flags=0 | Length |
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| Shared Key Identifier | HMAC Identifier |
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| |
\ HMAC /
/ \
/ +-------------------------------\
| | Padding |
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
Figure 5
Type: 1 byte (unsigned integer)
This value MUST be set to 0x0F for all AUTH-chunks.
Flags: 1 byte (unsigned integer)
SHOULD be set to zero on transmit and MUST be ignored on receipt.
Length: 2 bytes (unsigned integer)
This value holds the length of the HMAC in bytes plus 8.
Shared Key Identifier: 2 bytes (unsigned integer)
This value describes which endpoint pair shared key is used.
HMAC Identifier: 2 bytes (unsigned integer)
This value describes which message digest is being used. Table 2
shows the currently defined values.
HMAC: n bytes (unsigned integer)
This holds the result of the HMAC calculation.
Padding: 0, 1, 2, or 3 bytes (unsigned integer)
If the length of the HMAC is not a multiple of 4 bytes, the sender
MUST pad the chunk with all zero bytes to make the chunk 32-bit
aligned. The Padding MUST NOT be longer than 3 bytes and it MUST
be ignored by the receiver.
The control chunk AUTH MUST NOT appear more than once in an SCTP
packet. All control and data chunks that are placed after the AUTH
chunk in the packet are sent in an authenticated way. Those chunks
placed in a packet before the AUTH chunk are not authenticated.
Please note that DATA chunks can not appear before control chunks in
an SCTP packet.