NAME

  AbortInShutAckSend.seq - ABORT chunk is received in SHUTDOWN-ACK-SENT State

PURPOSE

  To check that receiving ABORT message in SHUTDOWN-ACK-SENT State can
  terminate an association.

SYNOPSIS

  ./AbortInShutAckSend.seq [-tooloption ...] -pkt ./AbortInShutAckSend.def
    -tooloption : v6eval tool option
  See Also: ../common/STD_PKT_COMMON.def
            ../common/SCTP_COMMON.def

PRE-TEST CONDITION

  Association is not established between endpoint A and B. Arrange
  the data in endpoint A such that SHUTDOWN message is sent to
  endpoint B.

TEST PROCEDURE

  Endpoint A                           Endpoint B                ULP
  (ESTABLISHED)                        (ESTABLISHED)

  SHUTDOWN           -------------->

                    <---------------   SHUTDOWN-ACK

  ABORT             ---------------->  Association is removed
                                              Communication Lost  --------->

  TEST DESCRIPTION:

  1. Try to terminate an association between endpoint A and endpoint B by
     sending SHUTDOWN message from endpoint A. SHUTDOWN-ACK message will
     be send from endpoint B. Don't send the SHUTDOWN-COMPLETE from the
     endpoint A.
  2. Attempt to terminate an association between endpoint A and endpoint 
     B by sending ABORT message.
  3. Check A: No Acknowledgement is sent for the ABORT message and 
     association is removed.
  4. Check B: ULP are reported of the association closure.

NOTE

  None

REFERENCE

  RFC 4960

  9.1.  Abort of an Association

    When an endpoint decides to abort an existing association, it MUST
    send an ABORT chunk to its peer endpoint.  The sender MUST fill in
    the peer's Verification Tag in the outbound packet and MUST NOT
    bundle any DATA chunk with the ABORT.  If the association is aborted
    on request of the upper layer, a User-Initiated Abort error cause
    (see Section 3.3.10.12) SHOULD be present in the ABORT chunk.

    An endpoint MUST NOT respond to any received packet that contains an
    ABORT chunk (also see Section 8.4).

    An endpoint receiving an ABORT MUST apply the special Verification
    Tag check rules described in Section 8.5.1.

    After checking the Verification Tag, the receiving endpoint MUST
    remove the association from its record and SHOULD report the
    termination to its upper layer.  If a User-Initiated Abort error
    cause is present in the ABORT chunk, the Upper Layer Abort Reason
    SHOULD be made available to the upper layer.